Other Controller Views - Yamaha VL-7 Owner's Manual

Getting Started

Other Controller Views

If you press the
controller view:
The controller parameters listed in this screen are not in the same category as those
discussed in the preceding section, and therefore need to be introduced separately. All of
the related parameters will be discussed in detail in the Feature Reference manual (pages
listed below).
Sustain
Portamento
Time MIDI
Ctrl
Effect Ctrl
Controller
The § function button calls the Continuous Slider ("CS") controller view, which
will look something like this:
The continuous sliders can not be assigned to the instrument controller parameters
listed above, but can be independently assigned to several other parameters that you can
control in real time while playing. The parameters available for editing via the continuous
sliders are individually preset for each voice. You can select from the available range by
using the "Continuous Slider" assignment function described on page 40 of the Feature
Reference manual.
The continuous slider view shows you which parameters are assigned to which
controller as well as the current positions of the controllers and parameter values.
The Controllers
function button from the play mode you'll see the following
Indicates whether sustain control is on or off.
( Feature Reference manual, page 33)
This line indicates the current portamento status: "Full Time" or "Fingered".
( Feature Reference manual, page 38)
A MIDI controller can be assigned to control portamento time. This line
indicates whether Time MIDI Control is turned "on" or "off".
( Feature Reference manual, page 38)
Any physical controller can be assigned to control certain of the VL7's effects in
certain ways: the wet/dry balance of the pitch change effect, the feedback delay
send level, or the reverb send level. This line indicates which effect parameter
is assigned for control.
( Feature Reference manual, page 43)
This line indicates which controller is assigned to control the effect parameter
shown in the "Effect Ctrl" line, above.
( Feature Reference manual, page 43)
47