Table of Contents
Advertisement
Adjusting Volume and Tone
Parts Identification (Fig. 7)
{1] Volume/Audio adjustment
Open
} Loudness
4
[5] Front panel
6 | Display
Humination
ig
clor
[10] Frequency selector
118] Shift
119] Cassette slot
120] Eject
(Fig. 9)
{32} Sub-woofer
{33} Loudness
Switching Power On
Tuner
Press button [9] to switch the tuner power on. Press
button [9] again to switch the power off.
Tape
Press button (3] to open the front panel, and load a
cassette in through cassette slot {19]. The cassette
will play. To eject the cassette, press button [3] to
open the front panel and press button [20].
Source Selector
When a cassette is joaded and button [9] is pressed,
the source shifts in the order tape — tuner — power
off. If this unit is combined with a multi-play CD
player sold separately such as CDX-M30, the source
shifts in the order multi-play CD player — tape —
tuner —~ power off.
Note:
Adjusting Audio
Press button [1] to adjust the volume. Each press of
button [18] changes the display and the function of
button [1] as follows:
Volume — Fader 1 — Fader 2 — Bass — Middle —
Treble -~ Balance
Adjusting Volume
Pressing the (+} side of button [1] increases the
volume, while the (-) side decreases it.
(Display shows "VOLO0" — "VOL30".}
+
While driving, keep the volume low enough that
you can hear sounds from outside the vehicle.
Adjusting the Fader
This unit has two faders: Fader 1 (displayed as
"FADI") which adjusts this unit's built-in amp front
output and rear output and Fader 2 (display as
"FAD2") which adjusts the built-in amp's overall
output, the front pre-out output as well as the rear
pre-out output.
+
When combining this unit with a graphic equalizer,
the fader adjustment is carried oul on the graphic
equalizer. For details on how to adjust Fader 1 and
Fader 2 in this situation, see "Combining this unit
with a graphic equalizer" in the next item.
*
When the sub-woofer function is used, the Fader 2
function does not work. (See "Using the Sub
woofer" on the next item.)
+
Far details on Speakers 11]
explanation of Fader 1 and Fade
diagram on the next item.
Fader 1
Pressing the (+) side of button [1] decreases the
volume from Speaker
nd pressing
the (~) side
decreases the volume from Speaker /2). (Display
shows "FAD1 F9" — "FAD1 R9".}
Fader 2
Pressing the (+) side of button [1] decreases the
volume from Speaker [5] and pressing
the (-} side
decreases the volume from Speaker [4]. (Display
shows "FAD2 F9"— "FAD2 R9".)
mentioned in the
2, see the wiring
Notes:
+
When either Speaker (2) or Speaker [3] is not
connected, set Fader 1 to its center position, "FAD1
0," Adjust the Speaker [4] and Speaker &) output
with Fader 2.
+
When Speaker [8 i s not connected, set Fader 2 to
i t s
center position,
"FAD2 0". Adjust the Speaker
2, and Speake
utput with Fader 1.
Advertisement
Table of Contents
