Table of Contents
Advertisement
Carry out the following before
connections and installation
When not connecting a graphic
equalizer to this unit
Make sure that the MAIN-IN switch on the bottom of
his unit is OFF. This unit's audio is not output if this
switch is ON,
s e switch to OFF.
When connecting a graphic
equalizer to this unit
Make sure that the MAIN-IN switch on the bottom of
this unit is ON. If you forget to switch to ON, the
graphic equalizer will nat work correctly
| MAINI
OFF.
18
Connections
Note:
+
Do not wire Orange leads (for constant-feed
power supply) by cutting a hole into the engine
compartment and connecting directly to the
battery.
*
Do not cut cords to shorten them. This is
dangerous because it may prevent the protection
circuit from operating correctly.
+
Do not cut into the insulation of this unit's power
cord to take out power for another unit! This is
dangerous because it can overload and overheat
the power cord.
+
Cover unused terminais with tape to prevent
electrical shorts.
+
Since a unique BPTL
uit is employed, never
wire so the speaker leads
are directly grounded ar
the left and right speaker > jeads are common.
+
Speakers connected to this unit must be high-
power type possessing maximum input of at least
30W and impedance of 4 to 8 ohms. Connecting
speakers with output and/or impedance values
other than those noted here can damage the
speakers.
ACC position
Fig.1
Fig.2
No ACC pasition
Advertisement
Table of Contents
