Load The Pre-Programmed Voice Data - Yamaha VL-1m Owner's Manual

Getting Started

Load the Pre-programmed Voice Data

Although the factory pre-programmed voices are stored in the VL1-m internal
memory when the instrument is initially shipped, there is always a possibility that all or
part of the memory has been erased or modified by the time the instrument gets to you.
Here's how you can re-load all the pre-programmed data from the supplied voice disk.
Loading the pre-programmed voices overwrites any other data that is in
NOTES
the VL1-m internal memory, so if you have any important voices in memory make
sure it is safely saved to disk before loading the data — Feature Reference
manual, page 164.
1.
Insert the Voice Disk
Insert the VL1-m voice disk into the disk drive. The sliding disk shutter should go
in first, and the label side of the disk should face upward.
2.
Select the Utility Mode System Page
Press the U button to select the utility mode.
If the Memory Protect function has been turned on (the default setting
NOTES
is "off"), it must be turned off before loading the data.
Use the cursor buttons to move the cursor to " 5:Miscellaneous ", then press
[ to call the " Miscellaneous " function page. Use the cursor buttons to
select the " Memory Protect " parameter, then press = to turn memory
protect " off ".
3.
Select the Disk Function Directory
Press the £ function button ("Disk") to select the utility mode disk function
directory.
Setting Up
30