Yamaha S-03SL Owner's Manual page 76

11-1. PEGSclSns (PEG Scale Sensitivity)
11-2. PEGSclCN (PEG Scale Center Note)
You can set PEG scale parameters for each Element.
These parameters control the PEG speed and the
degree of pitch change according to the position of the
notes played on the keyboard.
PEGSclSns
+0
PAGE PART ELEM KEY
11 E 1
OCTAVE
■ PEGSclSns
This determines the sensitivity of the PEG Rates for
each element to note position. In other words, the
speed of the pitch change varies according to the
range of the keyboard that is played. The PEGSclCN
parameter below is used as the basic or central pitch
for this parameter. A positive setting will cause
slower changes for lower notes and faster changes
for higher notes. A negative setting will have the
opposite effect.
❏
Settings: –7~+7
■ PEGSclCN
This determines the basic or central pitch used by
the PEG Scale Sensitivity parameter above. When
the center note is played, the PEG behaves according
to its actual settings. The pitch change
characteristics for other notes will vary in
proportion to the EG Rate settings.
❏
Settings: C-2~G8
n You can also set this parameter by pressing the
respective note on the keyboard while holding down
the [ENTER] button.
Positive value
Speed of PEG
pitch change
Lower range
Basic pitch
Negative value
Lower range
Basic pitch
76
Element Pitch
PEGSclCN
C3
PAGE PART ELEM KEY
11 E 1
OCTAVE
+
Higher range
–
+
Speed of PEG
pitch change
Higher range
–
12-1. PEGRtVel (PEG Rate Velocity)
12-2. PEGLvlVel (PEG Level Velocity)
This determines how the Pitch Envelope Generator
(PEG) responds to note velocity.
PEGRtVel
+0
PAGE PART ELEM KEY
12 E 1
OCTAVE
❏
Settings: –7~+7
■ PEGRtVel
Set the velocity sensitivity of the PEG's Rate (speed)
parameters. Positive settings will cause the pitch to
rised when you play the keyboard harder (for a large
Velocity value). A negative setting will have the
opposite effect.
■ PEGLvlVel
Set the velocity sensitivity of the PEG Level.
Positive settings will cause the pitch to rise the
harder you play the keyboard and negative settings
will cause it to fall.
PEGLvlVel
+0
PAGE PART ELEM KEY
12 E 1
OCTAVE