Yamaha S-03SL Owner's Manual page 63

Music synthesizer
Hide thumbs Also See for S-03SL:
Table of Contents

Advertisement

11-1. Cutoff
11-2. Resonance
You can set Filter parameters to change the tonal
characteristics of each Part
Cutoff
+00
PAGE
PART
ELEM
KEY
11
1
OCTAVE
Filter is the section of the tone generator that changes
the tonal qualities of a Voice by passing only a limited
frequency range and cutting signals outside that range.
The S03 employs an LPF (low pass filter).
❏ Settings: –64 ~ +63
■ Cutoff
Set the Cutoff frequency of the low pass filter. Only
frequencies below this point are passed.
Level
Range passed
Cutoff
■ Resonance
Set the amount of Resonance (harmonic boost)
applied to the signal around the Cutoff frequency.
This is a useful way of adding further character to
the sound.
Level
Resonance
Cutoff
Resonance
+00
PAGE
PART
ELEM
KEY
11
1
OCTAVE
Cutoff range
Frequency
Frequenc
12-1. Attack Tm (Attack Time)
12-2. Decay Tm (Decay Time)
12-3. Releas Tm (Release Time)
This determines the EG (Envelope Generator)
Parameters for each Part. There are three parameters
governing the transition in tone and output level from
the moment a note is pressed on the keyboard to the
moment it is released or the point at which the level
has faded to zero.
n These three parameters affect both the AEG and the
FEG.
Attack Tm
Attack Tm
+00
PAGE
PAGE
PART
PART
ELEM
ELEM
KEY
KEY
12
12
1
1
OCTAVE
OCTAVE
Releas Tm
+00
PAGE
PART
ELEM
KEY
12
1
OCTAVE
Level
Attack
Decay
Time
Time
Key on
❏ Settings: –64 ~ +63
■ Attack Tm
Determines the transition time from the moment a
key on the keyboard is pressed to the point at which
the level of the Voice reaches its peak. Positive
values will lengthen the transition time and negative
values will shorten it.
■ Decay Tm
Determines the transition time from the point at
which the level of the Voice reaches its peak to the
point at which it levels off. Positive values will
lengthen the transition time and negative values will
shorten it.
■ Releas Tm
Determines the transition time from when the key is
released to when the sound level decays to zero.
Positive values will lengthen the transition time and
negative values will shorten it.
Decay Tm
+00
PAGE
PART
ELEM
KEY
12
1
OCTAVE
Time
Release
Time
Key off
63
Part Tone

Advertisement

Table of Contents
loading

This manual is also suitable for:

S03

Table of Contents