Table of Contents
Advertisement
The Adapter Handler uses a default 5250 twinax card memory address of
0000 hex. Use the -A command line option to specify a different memory
address setting. The setting you specify must match the memory address
your 5250 twinax card uses.
The Adapter Handler uses a default 5250 twinax card
1/0
port address of
368 hex. Use the -I command line option to specify a different
1/0
port
address setting. The setting you specify must match the 1/0 port address
your 5250 twinax card uses.
Use the -U command line option to update the Adapter Handler's
configuration settings. The file L5250AH.COM must be in the current
directory when you use this option. The Adapter Handler will terminate
itself automatically, saving the new settings to use at the next startup
time. You will see a message verifying that the configuration settings
have been updated.
If you do not specify -U, the Adapter Handler will use the specified
settings only for the current session.
1.5
Running AS/400 PC Support
Make sure you are working from the PCS directory. Make sure your
cursor is at the DOS prompt. Enter the following command to start
AS/400 PC Support:
STARTPCS
This command will invoke the batch file STARTPCS.BAT, which you
modified to load the L5250AH Adapter Handler.
1-6
Advertisement
Table of Contents
