Camec COMPACT RV II User Manual page 27

NZ AU
Problem Cause
Temperature sensor error.
Heating error.
Motor error.
Water level sensor error.
/
Abnormal communication error.
or
10.3 Troubleshooting without display code
Problem
Washing machine
fails to operate.
Washing machine
water.
Machine is draining
Drainage failure.
Strong vibration
while spinning.
Operation stops
before completing
wash cycle.
Operation stops for
a period of time.
More information https://www.caravansplus.com.au
Cause
Programme is not yet started.
Door is not properly closed.
Machine has not been switched on.
Power failure.
Child lock is activated.
No water.
Inlet hose is kinked.
Water pressure is less than 0.03
MPa.
Door is not properly closed.
Water supply failure.
Height of drain hose is below 80
cm.
Drain hose end could reach into
water.
Drain hose is blocked.
Drain hose end is higher than 100
cm above floor level.
Not all transportation bolts have
been removed.
Appliance has no solid position.
Machine is overloaded.
Water or electric failure.
Appliance displays error code.
Problem due to load pattern.
Programme performs soaking cycle.
10-Troubleshooting
Solution
Contact the National Customer Support Team
Contact the National Customer Support Team
Contact the National Customer Support Team
Contact the National Customer Support Team
Contact the National Customer Support Team
Solution
Check programme and start it.
Close the door properly.
Switch the machine on.
Check power supply.
Deactivate child lock.
Check water tap.
Check inlet hose.
Check water pressure.
Close the door properly.
Ensure the water supply.
Make sure that height of drain
hose is between 80 to 100 cm
Make sure the drain hose is not
in water.
Unblock drain hose.
Make sure that drain hose is
properly installed.
Remove all transportation bolts.
Ensure solid ground and a ev-
elled position.
Check load weight and balance.
Check power and water supply.
Consider display codes.
Reduce or adjust load.
Cancel programme and restart.
27