Yamaha PLG150-DR Owner's Manual page 23

I MIDI port setting (MIDI Setup)
Before setting the MIDI port on the Plug-in Board Editor, you should set the MIDI port as follows.
This is the port that you'll use in the Plug-in Board Editor.
G Using the Plug-in Board Editor as a stand-alone application
1
Start the Plug-in Board Editor.
2
Click the MIDI Setup button in the Toolbar called up via step #1.
3
In the MIDI Setup window called up via step#2, select the MIDI In/Out/Thru port of the
"mother" device.
• MIDI driver software is needed to set the port here. The appropriate MIDI driver is contained in the
NOTE
CD-ROM included with the "mother" device.
• When the "mother" device and your PC are connected with a USB cable, select "YAMAHA USB
OUT xxx." When they are connected with serial cable, select "YAMAHA CBX Driver." For details,
refer to the owner's manual of the "mother" device.
G Using the Plug-in Board Editor in the client application as a plug-in software
Select the relevant MIDI port from the MIDI Setup dialog in the client application. Refer to the client
application owner's manual.
MIDI Setup button
About the Included CD-ROM
23