Parameters; Native Part Parameters - Yamaha PLG150-DR Owner's Manual

Parameters

Native Part Parameters

These parameters are used to offset the actual settings (made on the host device) of the voices of the
PLG150-DR/PLG150-PC Plug-in Board. Tune, Pan, Level, and other settings can be made for each
of any four instruments, and Insertion effects can also be applied.
Keep in mind that these offset Part parameters do not permanently change the original kit settings.
Also remember that for parameters with values, a setting of "0" results in no change to the original
setting, while positive and negative values change the setting accordingly. For example, if the original
Pan setting for a sound is all the way to the left, a setting of "0" for the Pan parameter here does NOT
represent "center" — it simply keeps the sound at its current hard-left position.
G Note Select 1 - Note Select 4
This determines the specific note (instrument sound) for which the same numbered Native Part
parameters will be effective. Set this parameter to the note (1 - 4) you wish to edit, then set the cor-
responding parameters (1 - 4) below to edit it.
Range: C-2 — G8, Off
G Note Select 1 Tune - Note Select 4 Tune
This determines the pitch of the selected note's instrument. The greater the value the higher the
pitch. Negative values lower the pitch.
Range: -64 — +00 — +63
G Note Select 1 Level - Note Select 4 Level
This determines the level or volume of the selected note's instrument.
Range: -64 — +00 — +63
G Note Select 1 Pan - Note Select 4 Pan
This determines the stereo position of the selected note's instrument. The lower the value (more
negative), the further left the sound is in the stereo image. The higher the value (more positive), the
further right the sound is.
Range: -127 — +00 — +127
G Note Select 1 Ins Eff - Note Select 4 Ins Eff (Insertion Effect)
This determines whether the PLG150-DR/PLG150-PC's built-in Insertion effect is applied to the
selected note's instrument or not. (When set to "on," the Insertion effect is applied.) When this is
set to "Inst," the original setting for the kit is maintained.
Settings: off, on, Inst
G Note Select 1 Rev Send - Note Select 4 Rev Send (Reverb Send)
This determines the level of the selected note's instrument that is sent to the PLG150-DR/PLG150-
PC's built-in Reverb effect. This parameter has no effect if the Insertion effect (above) is on.
Range: -127 — +00 — +127
13