Digital Effect - Yamaha MX12/4 Owner's Manual

9
ST control
This knob adjusts the monitor level of the external device (tape deck etc.) connected to the
TAPE IN jacks ( 5 ).
0

DIGITAL EFFECT

MONI control — This knob adjusts the level of the return signal which is sent from the inter-
nal digital effect to the MONI bus.
ST control — This knob adjusts the level of the return signal which is sent from the internal
digital effect to the ST bus.
Effect select switches — These switches select the effect type for the internal digital effect:
VOCAL, L HALL (large hall), or S HALL (small hall).
Do not attempt to turn off all switches or to simultaneously press two or more switches, since
this will cause malfunctions.
ON switch — This switch turns the internal digital effect on/off. When this is off, no signal will
be sent from the internal digital effect.
A
RTN
MONI control — This knob adjusts the level of the signal that is sent from the RTN jacks to the
MONI bus.
ST control — This knob adjusts the level of the signal that is sent from the RTN jacks to the ST
bus. If a signal is input only to the RTN L (MONO) jack, the same signal will be sent to the ST
bus L and R.
B
SEND
MONI 1 control — This knob adjusts the level of the MONI bus signal that is output to the
SEND MONI 1 jack.
EFFECT/MONI 2 control — This knob adjusts the level of the EFFECT bus or MONI bus sig-
nal that is output to the SEND EFFECT/MONI 2 jack.
The level of the signal that is sent from the EFFECT bus to the internal digital effect is fixed,
and cannot be adjusted (nor by this control).
Output select switch — This switch selects the signal that will be output to the SEND EFFECT/
MONI 2 jack.
EFFECT position (
MONI 2 position (
C
C-R•PHONES
Here you can select and adjust the signal that is output to the C-R OUT jack and the PHONES
jack.
C-R•PHONES control — This knob adjusts the output level to the C-R OUT jack and
PHONES jack.
Output select switch — These switches select the output signal for the C-R OUT jack and
PHONES jack.
When the upper switch is on (TAPE IN
jacks will be output.
When the upper switch is off (
• When the lower switch is off (ST
• When the lower switch is on (EFFECT/MONI
Meter — The LEDs indicate the output level before the C-R•PHONES control. A position of 0
indicates nominal level, and when clipping level is approached, PEAK will light red as a warn-
ing.
) — The EFFECT bus signal will be output.
) — The MONI bus signal will be output.
PUT jacks will be output.
SEND MONI 1 jack will be sent to the L channel, and the SEND
EFFECT/MONI 2 signal will be sent to the R channel.
Master control section
), the signal from the TAPE IN
)
), the same signal as the ST OUT-
), the signal of the
MX12/4—Owner's Manual
5