Digital Effect; Rear Input/Output Section - Yamaha MG102C Owner's Manual

DIGITAL EFFECT

1
2
3
4
5

Rear Input/Output Section

1
*Only the MG82CX has digital effects.
1
FOOT SWITCH Jack
A YAMAHA FC5 foot switch (sold separately) can be connected to this
jack and used to toggle the digital effects ON and OFF.
2
PROGRAM Dial
Selects one of the 16 internal effects. See page 18 for details about the
internal effects.
3
PARAMETER Control
Adjusts the parameter (depth, speed, etc.) for the selected effect.
The last value used with each effect type is saved.
NOTE
4
ON Switch
Switches the internal effect on or off. The internal effect is applied only
if this switch is turned on. The switch lights orange when on.
An optional YAMAHA FC5 foot switch (sold separately) can be used to
toggle the digital effects ON and OFF.
NOTE
5
EFFECT RTN Control
Adjusts the signal level sent from the internal digital effect unit to the
STEREO buses.
MG82CX
1
POWER Switch
Use this switch to turn the mixer's power ON or to STANDBY mode.
2
AC ADAPTOR IN Connector
ConnectConnect the supplied PA-10 power adaptor to this connector
(see page 5).
2
When you change to a different effect type, the mixer automat-
ically restores the value that was previously used with the
newly selected effect (regardless of the current position of the
PARAMETER Control knob).
These parameter values are reset when the power is turned off.
The ON switch lights and the internal effect unit is active by
default when the power is initially turned on.
Note that a small current continues to flow while the switch
is in the STANDBY position. If you do not plan to use the
mixer for a while, be sure to unplug the AC adaptor from the
CAUTION
wall outlet.
Use only the PA-10 adaptor included with this mixer. Use of
a different adaptor may result in fire or electric shock.
CAUTION
MG82CX/MG102C Owner's Manual
Reference
Front & Rear Panels
13