Yamaha MU90R Owner's Manual page 101

PERFORMANCE MODE
Settings: off, on
HINT
You can use the MU90R strictly as an effect processor for the A/D input (for example, your
guitar or microphone) by Soloing the appropriate A/D Part (A1 or A2).
Assignable Controller 1 Control Change Number (AC1 CC No.)
Same as the corresponding parameter in the Multi Edit mode (page 70),
with the exception that AC1 in the Performance mode can also control
LFO filter modulation (see Assignable Controller 1 LFO Filter Modu-
lation Depth below).
Assignable Controller 1 Filter Control (AC1 FilCtrl)
Same as the corresponding parameter in the Multi Edit mode. (See page
71.)
Assignable Controller 1 Amplitude Control (AC1 AmpCtrl)
Same as the corresponding parameter in the Multi Edit mode. (See page
72.)
Assignable Controller 1 LFO Filter Modulation Depth
(AC1LFOFMod)
This determines the degree to which Assignable Controller 1 (AC1) af-
fects the LFO modulation of the Filter. This creates a regular and con-
tinuous "wah-wah" or filter sweep effect. The higher the value, the
greater the LFO filter modulation. (The control number used for AC1
is set in the Assignable Controller 1 Control Change Number param-
eter above.)
Range:
92
This determines whether A/D Parts are enabled for the Performance
or not. When set to "on," Parts 3 and 4 are automatically set as A/D
Parts (A1 and A2).
Graphically shows the AC 1 Filter Modulation Depth setting.
000 — 127