Attachthe Emergency Release Ropeand Handle; Electrical Requirements - Craftsman 139.53918D Owner's Manual

INSTALLATION STEP 9
Attachthe Emergency Release Ropeand Handle
1. Insert one end of the emergency release rope through the
handle. Make sure that "NOTICE"is right side up. Tie a knot at
least 1 inch (2.5 cm) from the end of the emergency release
rope.
2. Insert the other end of the emergency releaserope through the
hole in the trolley releasearm. Mount the emergency release
within reach, but at least 6 feet (1.83 m) abovethe floor,
avoiding contact with vehicles to prevent accidental releaseand
secure with a knot.
NOTE:If it is necessary to cut the emergency releaserope, seal
the cut end with a match or lighter to prevent unraveling. Ensure
the emergency releaserope and handle are above the top of aft
vehicles to avoid entanglement.
INSTALLATION STEP 10
Electrical Requirements
To avoid installation difficulties, do not run the opener at this
time.
To reduce the risk of electric shock, your garage door opener has
a grounding type plug with a third grounding pin. This plug will
only fit into a grounding type outlet. If the plug doesn't fit into the
outlet you have, contact a qualified electrician to install the proper
outlet.
If permanent wiring is required by your local code, refer to the
following procedure.
To make a permanent connection through the 7/8" hole in the top
of the motor unit:
1. Removethe motor unit cover screws and set the cover aside.
2. Removethe attached 3-prong cord.
3. Connect the black (line) wire to the screw on the brass
terminal; the white (neutral) wire to the screw on the silver
terminal; and the ground wire to the green ground screw.
The opener must be grounded.
4. Reinstallthe cover.
To avoid installation difficulties, do not run the opener at this
time.
To prevent possible SERIOUSINJURYor DEATHfrom a falling
garage door:
• If possible, use emergency releasehandle to disengage
trolley ONLYwhen garage door is CLOSED.Weak or broken
springs or unbalanceddoor could result in an open door
falling rapidly and/or unexpectedly.
• NEVERuse emergency releasehandle unless garage doorway
is clear of persons and obstructions.
• NEVERuse handle to pull door open or closed. If rope knot
becomes untied, you could fall.
Trolley
I
__e Arlm_ _
Emergency
_ _verhandnot
Release Handle
To prevent possible SERIOUSINJURYor DEATHfrom
electrocution or fire:
• DisconnectALL electric and battery power BEFORE
performing ANY service or maintenance.
• Garage door installation and wiring MUST be in compliance
with ALL local electrical and building codes.
• NEVERuse an extension cord, 2-wire adapter, or change
plug in ANY way to make it fit outlet. Be sure the opener
is grounded.
PERMANENTWIRING
CONNECTION
Ground Tab
Green
Ground Screw
Ground Wire Wire
White Wire Black Wire
19