Midi - Yamaha FS1R Owner's Manual

• 05: KN CtrlMode
Knob Control Mode
Settings: abs, rel
Determines whether the FS1R control knobs will control values in an absolute ("abs") or relative ("rel") manner when
the lower knob mode button is engaged. When "abs" is selected the same knob position will always produce the
same value, while in the "rel" mode rotating a knob will produce a relative change in the corresponding
value.

MIDI

• 01: Device Num
Device Number
Settings: off, 1 ... 16, all
Sets the FS1R MIDI device number. This number must be matched to that of any connected MIDI device to and
from which MIDI System Exclusive data is to be transferred. A setting of "off" means that no device number is
selected, while a setting of "all" allows System Exclusive transfer via all 16 available MIDI device numbers.
• 02: DumpIntrval
MIDI Bulk Dump Interval
Settings: 50, 100, 150, 200, 300
Sets the length of time intervals to be inserted between data blocks during a "Dump Out" operation (page 77). The
required interval will depend on the receiving MIDI device. The settings are in milliseconds: i.e. 50 milliseconds, 100
milliseconds, etc. Try adjusting this parameter if the receiving MIDI device generates a "MIDI Buffer Full" error
message while receiving a bulk dump from the FS1R.
• 03: RcvBulkDump
Receive Bulk Dump Switch (only available when 04: Rcv SysExcl "on")
Settings: off, on
This parameter determines whether or not the FS1R will receive MIDI bulk dump data. Bulk dump data is received
when this parameter is "on", and ignored when this parameter is "off".
• 04: Rcv SysExcl
Receive System Exclusive Switch
Settings: off, on
This parameter determines whether or not the FS1R will receive MIDI system exclusive messages. System exclusive
data is received when this parameter is "on", and ignored when this parameter is "off". Refer to the separate "Data
List" booklet for details on System Exclusive data which can be used with the FS1R.
• 05: Receive Note
Receive Note Data
Settings: all, odd, even
This parameter determines the type of MIDI note data that the FS1R will receive. All note data is received when this
parameter is set to "all", only even-numbered notes are received when set to "even", and only odd-numbered notes
are received when set to "odd".
72