Setting Functions Of Tool (Setting Mode) - Panasonic EYADA Series Operating Instructions Manual

SETTING FUNCTIONS OF TOOL (SETTING MODE)

1. Switching to Setting Mode
This unit can change settings according to the work.
To change settings, switch to setting mode.
Operation mode
Detection
lamp off
■ Switching to Setting Mode
Set the forward/reverse
lever to the trigger switch
lock position.
Set it to the "○" position.
Hold down the OK button.
A buzzer sounds short twice (two
short beeps), and the detection
lamp blinks yellow.
2. Selecting Menu
OK button
22
EN
Setting mode
Yellow
detection lamp
blinking
Blinking yellow
Two short
beeps
Display
▲ button
▼ button
■ Back to Operation Mode
Hold down the OK button
while you are in setting
mode (the detection lamp is
blinking yellow).
A buzzer sounds short three
times (three short beeps), and the
detection lamp turns off.
Release the forward/reverse
lever from the trigger switch
lock position.
When you set it to the F position
and the R position, the motor
rotates forward (clockwise)
and reverses (anticlockwise)
respectively.
You can select a menu by pressing the
▼ and ▲ buttons while you are in setting
mode.
A menu to be selected appears on the
display.
Press the OK button to confirm the
selected menu.
Three short
beeps