Capacity And Specifications - Panasonic EYADA Series Operating Instructions Manual

CAPACITY AND SPECIFICATIONS

Tool Capacity
Model No.
Recommended Work
Torque Setting Range 0.3 N ・ m to 2.5 N ・ m
Torque Setting Steps
Fastening Torque
Accuracy*
Speed
<Measurement conditions>
Based on our specified measurement conditions.
* Fastening torque and fastening torque accuracy vary depending on the work status.
Be sure to check them with actual work before use.
Tool Specifications
Power Supply
Motor
Bit Holder
Size (Estimated
Dimensions)
Mass (Weight)
Trigger Switch Mode
Communication
function
Output Signals
Input Signals
Operation Panel
(Display)
Operation Button
EYADA212XC
Machine screw:
M2.5 to M4.5
96 steps
±10%
1200 revolutions per
minute
(10-step adjustment)
Power supplied by power adapter (sold separately) 100 to 240 V AC 50/60 Hz
Brushless motor (30 V DC)
One-touch bit locking mechanism
Applicable bits ( hex shank of 6.35 mm across flats,
single-ended 9 mm to 13 mm, double-ended 12 mm to 17.5 mm)
Overall Length: 271 mm / Grip diameter: φ38 mm
About 630 g
Both lever start mode and push start mode available (Switchable on a
single unit)
Wired (A separately sold communication cable is required.)
Fastening OK signal
Fastening NG (NOK) signal
Count-up signal
Motor forward signal
Motor reverse signal
Drive permission signal
7-segment display
OK button / ▼ button / ▲ button
EYADA218XC
Machine screw:
M2.5 to M4
0.3 N ・ m to 2.0 N ・ m
1800 revolutions per
minute
(10-step adjustment)
EYADA407XC
Machine screw:
M3.5 to M5
1.5 N ・ m to 4.4 N ・ m
650 revolutions per
minute
(10-step adjustment)
49
EN