Fiat TIPO 5DOOR 2023 Owner's Handbook Manual page 322

from "Radio" mode to "Media" mode. If
the device used does not play, verify its
compatibility by selecting Media mode:
a dedicated message will appear on
the Uconnect™ system display.
WARNING After using a USB charging
port, we recommend disconnecting the
device (smartphone), always removing
the cable from the car port first, never
from the device fig. 297 or fig. 298 (for
versions/markets where provided).
Cables left flying or connected
incorrectly could compromise correct
recharging and/or the USB socket
condition.
NOTE The USB port handles
data transmission from the Pen
Drive/Smartphone, etc. and slow
recharging, which is not guaranteed as
it depends on the device type/brand of
the external device itself.
297
320
298
PHONE MODE
Phone mode activation
Press the "Phone" button on the
display to activate the Phone mode.
NOTE To consult the list of mobile
phones and supported functions, visit
the www.driveuconnect.eu website
Use the graphic buttons on the display
to:
dial the phone number (using the
graphic dial pad on the display);
display and call the contacts in the
phonebook of the mobile phone;
display and call contacts from the
registers of previous calls;
pair up to 10 phones/audio device
to make access and connection easier
and quicker;
transfer calls from the system to
the mobile phone and vice versa and
deactivate the microphone audio for
private conversations.
P2000486
The mobile phone audio is transmitted
through the car's sound system; the
system automatically mutes the radio
when the Phone function is used.
Pairing a mobile phone
WARNING Carry out this operation
only with car stationary and in safety
conditions; this function is deactivated
when the car is moving.
P2000487
The pairing procedure for a mobile
phone is described below: always
consult the handbook for the mobile
phone in any case.
To pair the mobile phone, proceed as
follows:
activate the Bluetooth ® function on
the mobile phone;
press the "Phone" graphic button on
the display;
if no phone is paired with the system
yet, the display shows a dedicated
screen;
access "Settings" and select "Add
device" to start the pairing procedure,
then search for the Uconnect™ device
on the mobile phone;
when prompted by the mobile
phone, use its keypad to enter the PIN
code shown on the system display or
confirm on the mobile phone the PIN
displayed;