Preparation For Use - Yamaha CC-90 Owner's Manual

PREPARATION FOR USE

For connecting with NX-S90
(Black wire with white line
black wire minus (–) terminal)
CTX-S90 (U.S.A. model)
To an AC outlet
R L
plus (+) terminal,
MX-S90
Speaker connection
Connect each speaker wire to the SPEAKERS terminals.
Cautions
•
Do not let the bare speaker wires touch each other as this
could damage the amplifier and/or speakers.
•
When connecting the speakers to this system, be sure to
connect the speaker wires properly. Do not mistake the
right channel for the left channel and the plus (+) terminal
for the minus (–) terminal.
•
Set the SPEAKERS SELECTOR switch on the rear panel
of MX-S90 to the proper position before connections.
If you use YAMAHA Active Servo Processing Speaker
System NX-S90, set this switch to "NX-S90".
If you use a speaker system other than NX-S90, set this
switch to "CONVENTIONAL".
Connecting the AC supply leads
These connections must be done after all other connections
have been completed.
•
First, plug the AC supply lead of MX-S90 into the AC
OUTLET on the rear of CTX-S90.
•
Next, plug the AC supply lead of CTX-S90 into a wall AC
outlet.
* Unplug the AC supply lead of CTX-S90 from the AC outlet
if the system is not to be used for a long period of time.
AC OUTLET (SWITCHED) on the rear panel of CTX-S90
Use this to connect the AC supply lead from another
component to CTX-S90.
The power to this outlet is controlled by the POWER switch
of CTX-S90 or the provided remote control transmitter.
This outlet will supply power to the connected component
whenever CTX-S90 is turned on.
The maximum power (power consumption of component)
that can be connected to the AC OUTLET (SWITCHED) is
420 watts.
It is the best way to connect the AC supply lead of MX-S90
to this outlet. By doing so, the power of the whole system
can be turned on/off by the POWER switch of CTX-S90 or
the provided remote control transmitter.
After the connection, keep the POWER switch of MX-S90
in the ON position.
12