Yamaha A3000 Owner's Manual page 17

[Save]
Save the edited content and close the Waveform Window.
[Don't Save]
Close the Waveform Window without saving the edited content. Your edits will
be lost.
[Cancel]
The Waveform Window will not be closed, nor will the edited content be
saved.
5.4. Save
Saves the edited sound data by overwriting it onto the original sound file.
5.5. Save As...
Saves the edited sound data as a new file of a different name. In this
dialog box you can also specify a different format (AIFF, Sd2f, or WAVE) for
saving.
5.6. Revert
Returns the edited content to the state which was last saved. Your edits up
to that point will be lost.
*It is not possible to Undo (cancel) this operation.
5.7. Resample...
This command converts the sampling frequency of the sound data.
A FIR filter is used for the conversion. The characteristics of this FIR
filter can be set by three parameters: FIR Order, Rejection, and Sampling
Rate.
<FIR Order>
Specify the coefficient of the FIR filter which will be used for the
conversion. The higher this value, the better the quality will be, but a
longer time will be required for processing.
<Rejection(dB)>
Specify the ratio at which aliasing noise will be canceled. As this value is
- 3 -