Yamaha A3000 Owner's Manual page 13

loop region shown in the time axis ruler, the mouse pointer will change
shape, and you can drag to left or right to modify the start/end points of
the loop region. By dragging the mouse within the loop region (brown, with
the default settings) in the time axis ruler, you can change the location of
the loop region without affecting the length of the loop. In addition, if
you hold down both the Option key and the Shift key and then click outside
the loop region shown in the time axis ruler, the loop region will be
extended to that point.
By clicking any other point in the time axis ruler, you can set the playback
start time to that location.
4.8. Overall waveform display (Overview)
The overall waveform display shows a graphic image of the entire sound file
that is currently opened by TWE. The rectangular bar (light green by
default) indicates the portion of the entire waveform that is currently
displayed at a higher magnification in the waveform display.
By clicking in the overall waveform display, you can specify the region of
the waveform which will be displayed in the waveform display. You can also
hold down the Option key and drag to specify the region of the waveform
which will be displayed in the waveform display.
4.9. Status bar
The status bar located in the lower part of the Wave window displapys the
following information, from left to right.
< Waveform scan ratio >
The progress of the scanning that is performed in order to generate the
waveform display data is displayed here as a percentage. When the scan is
completed, this will indicate "100.0%."
< Mouse cursor location on the time axis >
This indicates the location of the mouse pointer within the waveform display
area. The units are the same as those currently selected for the Time Ruler.
If the Time Ruler is not being used, this location will be shown as time
(hours:minutes:seconds.milliseconds).
- 13 -