Technics SC-CH404 Operating Instructions Manual page 55

Hide thumbs Also See for SC-CH404:
Table of Contents

Advertisement

Problem
Probable cause(s)
Suggested remedy
When there is a tele vision set nearby
The picture on the TV
disapears or stripes appear
on the screen.
The location and orientation of the antenna are
incorrect.
if you are using an indoor antenna, change to an
outdoor antenna.
The wiring at the back of the system is unsuitable.
Separate the antenna wire of the TV set from the
system.
While listening to ta pes
Sound is low. Intermittent,
or poor quality, noisy,
scratchy, or unsteady.
Heads are dirty.
Clean the heads.
The Dolby noise reduction is set in the wrong
position.
Set it to match the Dolby NR recording mode.
The deck does not enter the
recording mode.
The erase-prevention tabs are removed from the
cassette.
Attach tape to cover the space left by removal of the
erase-prevention tabs.
While listening to cc mpact discs
The display will not show
the correct Indication. Disc
play does not start when
you press the play button.
The disc is not positioned correctly in the disc tray.
Load the disc on the tray correctly.
The disc is loaded upside down.
Reload the disc.
The disc is dirty.
Wipe the disc with a soft doth.
The disc is scratched.
Replace the disc with a new one.
The disc is badly warped.
The disc is nonstandard one.
Replace the disc with a different one.
There is condensation inside the disc player.
Switch the power ON, and then wait for 60 minutes
before using the disc player.
While using the remote control
The system cannot be
operated with the remote
control.
The batteries are installed in the reverse polarity.
Re-insert the batteries in the correct polarity.
The batteries are worn.
Replace the batteries with new batteries.
55

Advertisement

Table of Contents
loading

Table of Contents