Table of Contents
Advertisement
You can use normal, chrome and metal tapes for recording.
The recording level and the noise reduction effect of the original
(playback) tape will be recorded on the new tape just as they were in
the original recording.
Check that the tape's erasure prevention tabs (see page 53) are
intact, and then insert the cassette into deck 2.
The leader tape must be wound on beforehand. (See page 30.)
Load cassettes.
For playback: Into deck 1
For recording: Into deck 2
Insert both cassette with the starting side
facing in front.
Press CLOSE to close each
deck's cassette holder.
ONE TOUCH TAPE EOT
NORMAL HIGH
Press one of ONE TOUCH
TAPE EDIT (NORMAL or HIGH)
to start recording with the de¬
sired editing speed.
NORMAL: When you wish to monitor
the sound while recording
HIGH:
When you wish to record at
high speed (about 2 times
normal speed)
While recording, both DECK 1 and DECK
2 indicators light. Tape direction Indicator
shows the tape direction of deck 2.
3
REVERSE NODE
Select the desired reverse
mode.
ZZl: Single-sided recording
CID: Two-sided recording
(forward side-* reverse side)
In case the tape length loaded in
deck 2 is longer than a tape in
deck 1. deck 1 repeats the play¬
back until deck 2 completes the
two-sided recording.
(8 times max.)
CO: Two-sided recording
(forward side—* reverse side)
4
\Ls
CCRjOC
Press CCRT to activate the
CCRT function. (See page 30.)
You can record without using the CCRT
function.
Set the tape direction to ">"
of deck 1 and deck 2.
Press DECK 1/2 and confirm both deck's
tape direction are
To change the tape direction, first press
>, and then □.
To record on the reverse side, set deck 2
to
u<"
tape direction. (In this case, be
sure to rewind the tape to the beginning
of the reverse side.)
36
□
|
To stop recording:
—'
Press □.
'O
Both decks will stop.
To record another tape on the remaining blank
portion of the tape:
Replace the tape for playback In deck 1, and then press NORMAL or
HIGH.
To enjoy another source while recording:
Press > on the compact disc player or TUNER/BAND on the
tuner/sound processor, and start the sound source.
You can change the volume level and tone quality without affecting
the recording.
For your reference:
For optimum results, use an editing tape of the same or higher
quality than the playback tape.
Notes
•Some TV sets generate noise that could be recorded during tape-
to-tape recording. To prevent the possibility of this, do not use this
system close to a TV set.
• Do not press CD edit recording buttons (J.FIT, ALBUM, LAST
FADE) while tape-to-tape recording is in progress. It changes the
tape-to-tape recording to the CD edit recording mode.
Advertisement
Table of Contents
