Table of Contents
Advertisement
^^mg^i&Qmpdct discs
Closing up the tape-end unrecorded sections
(LAST FADE)
LAST FADE
%
Press LAST FADE.
Lights.
<■>. ft
t
u-'j
>
The recording will start after the system completes steps 2-3 of
"One-touch operation" below.
Use this editing mode when you record more than
24
tracks.
To record with desired tone quality:
Select the desired tone quality (see pages 38-40), and start editing
To play back such recordings, press ON/FLAT on the tuner/sound
processor to set to FLAT.
To specify the tracks to be edited:
You can specify the tracks to be edited using the program plav
procedure. (See page 23.)
After completing step 5 on the previous page:
1. Press PROGRAM on the remote contof, and then specify the
tracks to be recorded in the desired sequene.
2. Press one of the one-touch editing buttons (ALBUM, J.FIT, LAST
FADE) to start editing.
To cancel one-touch editing:
Press □ on the cassette deck.
The compact disc player also stops.
You can progam up to 24 tracks (and also tracks numbering lower
than 24).
"FULL" appears on the display if you try to program more than
24 tracks.
One-touch editing operation:
1. The cassette deck will fast-forward and rewind to measure its
length. At the same time, CCRT function will be activated
(See page 30.)
2. The cassette deck will automatically advance the tape beyond
the leader tape, and then stop.
3. The compact disc player automatically scans for the peak (high¬
est) level of the entire disc
(Automatic Tape Level Setting—
ATLS),
then recording will start. ATLS is the function which scans
(fast search) for the peak (highest) level of the disc, and sets the
appropriate recording level. When ATLS is activated, no sound
will be heard.
It takes about 70 seconds to complete ATLS for a compact disc of
60 minutes.
When there are tracks allotted on tape side B:
After recording tracks allotted on tape side A, the cassette deck will
continue recording making the blank portion on tape side A to
measure the tape length.
After the edit recording has finished:
Ih.M^Ck automatical|y
enters the recording standby mode. When
LINK indicator flashes, it means you can edit tracks from same or
another disc in succession. (See page 34.)
To finish recording:
Press □ on the compact disc player and "LINK" indicator goes off.
33
Advertisement
Table of Contents
