Advertisement
ENGLISH
Note: In order to determine the exact position of the operator,
gear plate for 180° opening (fig. 13 c) and the required settings,
please refer to the instructions enclosed.
Gear plate for
180° opening
Note: For systems with 110° and 140° opening it is possible to fit the
(optional) open/close mechanical stops inside the housing case.
For installation details, please refer to the relative instructions
(fig.14)
Open
mechanical
stop
Note: grease the operator pinion and the fixing pivots of the two
levers. Do not oil the gears of the gear plate.
Note: Do not lubricate the release system for any reason.
4) Fasten the box cover by means of the screws supplied (fig. 15).
5) Install the second operator, if required, repeating the
operations described above.
6) Install the electronic control unit, referring to the dimensions
indicated in the relevant instructions.
6. START-UP
CAUTION: Before attempting any work on the system or on the
operator, always turn off power.
Observe points 10, 11, 12, 13, 14 of the GENERAL SAFETY
OBLIGATIONS.
Observing the instructions in Fig.3, lay the raceways and make
the electric connections of the control board to the selected
accessories.
Always separate power cables from control and safety cables
(push-button, receiver, photocells, etc...). To prevent any electric
noise whatever, use separate sheaths.
1) Program the control board according to your needs observing
the concerning instructions.
2) Switch on power to the system and check the condition of the
LEDs according to the table of the control board instructions.
7. TEST OF THE AUTOMATED SYSTEM
Check operating efficiency of the automated system and all
accessories connected to it.
Hand the "User's Guide" page to the Client, explain correct
operation and use of the operator and indicate the potentially
dangerous areas of the automated system.
8. MANUAL OPERATION
Should the need arise to operate the gate manually because of
a power failure or malfunction, the release device with key fitted
on the support bracket (fig. 1 - ref. 6) makes it possible to release
the system both from the inside and from the outside.
To operate the leaf manually, proceed as follows:
•
open the lid of the lock (fig. 16-ref. 1);
•
insert the release key in the lock (fig. 16-ref. 2);
•
turn the key in the direction of the post, as far as it will go (fig.
16-ref. 3);
•
pull the lever out (fig. 16-ref. 4);
•
operate the leaf manually.
Fig. 13 c
Close
mechanical
stop
Fig. 14
9. RETURNING TO NORMAL OPERATION
To restore normal operation, proceed as follows:
•
push the lever back into its home position (fig. 17-ref. 1);
•
insert the release key in the lock and turn it in the direction
opposite the post, as far as it will go (fig. 17- ref. 2);
•
operate the leaf manually until the lock is engaged in the
locking bracket (fig. 17-ref. 3);
•
close the lid of the lock.
Fig. 15
10.SPECIAL APPLICATIONS
There are no special applications.
11.MAINTENANCE
At regular intervals, check the structure of the gate and make
sure that the hinges are in perfect working order.
Periodically lubricate the pivot and ball in the support bracket,
through the lubricating bore shown in fig. 1- ref. 13. Make sure that
the pivots of the lever systems and the pinion are always well
lubricated.
Periodically check the correct adjustment of the electronic anti-
crushing and the efficiency of the release system enabling the
manual operation (see related paragraph).
The safety devices installed on the system need to be checked
every six months.
12.REPAIRS
For repairs, refer to authorised service centres.
8
3
1
2
4
Fig. 16
1
2
3
Fig. 17
Advertisement
