Table of Contents
Advertisement
Unpacking
This machine was carefully packaged for safe
transport. When unpacking, separate all enclosed
items from packaging materials and inspect them
for shipping damage. If items are damaged,
please call us immediately at (570) 546-9663.
IMPORTANT: Save all packaging materials until
you are completely satisfied with the machine and
have resolved any issues between Grizzly or the
shipping agent. You MUST have the original pack-
aging to file a freight claim. It is also extremely
helpful if you need to return your machine later.
SUFFOCATION HAZARD!
Keep children and pets away
from plastic bags or packing
materials shipped with this
machine. Discard immediately.
Needed for Setup
The following are needed to complete the setup
process, but are not included with your machine.
Description
•
Additional People ....................................... 1
•
Safety Glasses ........................................... 1
Cleaner/Degreaser (Page 8) ...... As Needed
•
•
Disposable Shop Rags ............... As Needed
•
Screwdriver Phillips #2 ............................... 1
•
Wrench or Socket 16mm ............................ 1
•
Hex Wrench 4mm ....................................... 1
•
Feeler Gauge ............................................. 1
•
Machinist's Square ..................................... 1
Model T27313 (Mfd. Since 12/15)
SECTION 2: SETUP
Qty
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Box 1 (Figure 2)
A. Copy Attachment ........................................ 1
B. Longitudinal-Feed Handwheel .................... 1
C. Support Arm Clamping Plates .................... 2
D. Support Arms (Short) ................................. 2
E. Support Arms (Tall) .................................... 2
F.
Hardware Bag (Not Shown) ........................ 1
—T-Bolts M10-1.5 x 100 ............................. 2
—T-Bolts M10-1.5 x 45 ............................... 2
—Cutting Tool ............................................ 1
—Support Arm Clamps .............................. 2
—Fender Washers 8mm ........................... 2
—Hex Nuts M8-1.25 .................................. 2
A
E
D
Figure 2. T27313 inventory.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Qty
B
C
-7-
Advertisement
Table of Contents
