Table of Contents
Advertisement
Unpacking
This machine was carefully packaged for safe
transport. When unpacking, separate all enclosed
items from packaging materials and inspect them
for shipping damage. If items are damaged,
please call us immediately at (570) 546-9663.
IMPORTANT: Save all packaging materials until
you are completely satisfied with the machine and
have resolved any issues between Grizzly or the
shipping agent. You MUST have the original pack-
aging to file a freight claim. It is also extremely
helpful if you need to return your machine later.
Needed for Setup
The following items are needed, but not included,
for the setup/assembly of this machine.
Description
•
Safety Glasses (for each person)............... 1
•
Cleaner/Degreaser .................... As Needed
•
Shop Rags.................................. As Needed
•
Disposable Gloves ..................... As Needed
•
Hex Wrench 4, 5, 8mm ........................1 Ea.
•
Phillips Head Screwdriver #2 ..................... 1
•
C-Clamps ................................................... 2
•
12" 2x4 Wood Block ................................... 1
•
Open-End Wrench 12, 14mm,
•
Power Drill .................................................. 1
•
Drill Bit & Tap ............................................. 1
•
Optional Mounting Hardware...... As Needed
•
Thread Locking Fluid.................. As Needed
•
Gear Oil (80-90W)...................... As Needed
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
Model T33926 (Mfd. Since 08/23)
SECTION 3: SETUP
Qty
⁄
" ......1 Ea.
11
16
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency replacements can be
obtained at your local hardware store.
Box 1 (Figure 5)
A. Power Feeder Assembly ............................ 1
B. Lower Elbow-Joint ...................................... 1
C. Base Bolt Pattern Template........................ 1
D. Indicator Sticker.......................................... 1
E. Angle Adjustment Scale ............................. 1
Rotation Knob M10-1.5 ............................... 1
F.
A
E
F
Figure 5. Box 1 inventory.
Box 2 (Figure 6)
G. Vertical Column Assembly ......................... 1
H. Overarm Shaft ............................................ 1
Hex Bolts M12-1.75 x 50 (Mounting)........... 4
I.
Lock Washers 12mm (Mounting)................ 4
J.
K. Vertical Travel Crank Handle...................... 1
L. Upper Elbow-Joint ...................................... 1
G
L
Figure 6. Box 2 inventory.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Qty
B
C
D
Qty
H
I
J
K
-13-
Advertisement
Table of Contents
