Needed For Setup - Grizzly T31850 Instructions Manual

Needed for Setup

The following items are needed, but not included,
for the setup/assembly of the Model T31850.
Description
• Additional Person ....................................... 1
• Safety Glasses (for each person) ..........1 Pr.
• Phillips Head Screwdriver #2 ..................... 1
• Tape Measure............................................. 1
• Shop Rags .................................. As Needed
DO NOT exceed table weight capacity of
275 lbs. Sudden change in dynamic load
at maximum weight capacity could cause
table to tip or collapse, resulting in serious
personal injury or property damage.
Wear safety glasses during
the entire setup process!
Assembly
The Model T31850 Adjustable Workbench Legs
must be fully assembled, and a table must be
attached before the machine can be used. Before
beginning the assembly process, gather all listed
inventory items.
To assemble workbench legs:
1. Attach side brackets to ends of support beam
with (4) M6-1 x 12 flat head cap screws (see
Figure 3).
x 4
Figure 3. Attaching side brackets.
-2-
Qty
Side Bracket
(1 of 2)
2. Insert lifting columns into ends of support
beams and secure with (8) M6-1 x 12 button
head cap screws (see Figure 4).
x 8
Figure 4. Attaching lifting columns.
3.
Attach feet to bottom of lifting columns with
(8) M6-1 x 16 button head cap screws (see
Figure 5).
Figure 5. Installing feet.
4. Place table (not included) face down on floor,
then place workbench legs on table).
Model T31850 (Mfd. Since 11/20)
x 8