Troy-Bilt TB25HT Operator's Manual page 8

INSTALLING AND ADJUSTING THE HANDLE
Installing the Handle
1. Push the handle down onto the upper shaft housing (Fig. 4).
Make sure the bolt hole faces to the right (Fig. 4).
2. Insert the bolt into the bolt hole and push it through (Fig. 4).
Tighten the bolt with a flat-head screwdriver, but do not tighten
the bolt completely .
3. Hold the unit in the operating position (Fig. 8). Move the handle
up or down the upper shaft housing to a comfortable location
(Fig. 4). Make sure the handle is positioned beyond the end of
the safety label (Fig. 4).
4. Tighten the bolt with a flat-head screwdriver until the handle is
secure.
Adjusting the Handle
If the handle requires adjustment:
1. Loosen the bolt with a flat-head screwdriver (Fig. 4).
2. Hold the unit in the operating position (Fig. 8). Move the handle
up or down the upper shaft housing to a comfortable location
(Fig. 4). Make sure the handle is positioned beyond the end of
the safety label (Fig. 4).
3. Tighten the bolt with a flat-head screwdriver until the handle is
secure.
Safety Label
Bolt Hole
Bolt
8
Handle
Upper Shaft
Housing
Fig. 4