During Operation; Overview Of The Machine Operating Characteristics - Toro Reelmaster 5610-D Operator's Manual

Overview of the InfoCenter Display (continued)
1. Bring the machine to a complete stop approximately 3.7 m (12 ft) from the maximum
transport speed of 10 mph.
2. On flat, dry pavement, mark out the start and end of 3.7 m (12 ft).
3. Drive the machine at the maximum transport speed of 16 km/h (10 mph) and remove
your foot at the start of the 3.7 m (12 ft).
4. Check if the machine stops within 0.6 m (2 ft) of the end mark (3.7 m or 12 ft).
5. Contact your Toro distributor if the stopping distance of the machine is not within 0.6 m
(2 ft) of this distance.
Overview of Reverse Speeds
Transport Reverse Speed
• If the maximum transport speed set by the supervisor is above 8.0 km/h (5.0 mph), the
maximum reverse speed is 8.0 km/h (5.0 mph).
• If the maximum transport speed set by the supervisor is at or below 8.0 km/h (5.0 mph),
maximum reverse speed is equal to the transport speed set by the supervisor.
Mowing Reverse Speed
• If the maximum mow speed set by the supervisor is above 6.4 km/h (4.0 mph), the
maximum reverse speed is 6.4 km/h (4.0 mph).
• If the maximum mow speed set by the supervisor is at or below 6.4 km/h (4.0 mph),
maximum reverse speed is equal to the transport speed set by the supervisor.
Overview of Displayed Traction Speeds
This machine displays estimated traction speeds in kilometers per hour (km/h) or miles per
hour (mph).
• The instantaneous speed is displayed in the upper left-hand corner of the cruise control
and virtual pedal stop screens.
• The traction speeds are estimated, and calibrated to be most accurate at 8.0 km/h (5.0
mph) while mowing. Displayed speeds are accurate when it is 0.8 km/h (0.5 mph) above
or below the display speed while driving on dry, flat pavement.
• Contact your authorized Toro distributor if the machine's observed speeds deviate more
than 2.4 km/h (1.5 mph) from the displayed speeds.

During Operation

Overview of the Machine Operating Characteristics

• This machine has an automotive-style throttle that is controlled by the traction pedal.
• This machine does not have a separate throttle switch or throttle lever.
• When you remove your foot from the traction pedal, the machine dynamically brakes to a
stop.
Operation: During Operation Page 5–14 3464-486 A