Table of Contents
Advertisement
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the cutoff baffle from the mower deck
(Figure
18).
4.
Remove the right mower blade; refer to
Removing the Blades (page
5.
Slide the right baffle under the mower deck, and
secure it using 2 knobs and the curved washers
(cupped side facing the mower) as shown in
Figure 16
and
Figure
Important:
Ensure that the tab on the far
right side of the right baffle is outside of the
mower and is flush with the mower wall.
6.
Install the right mower blade; refer to
the Blades (page
During Operation
During Operation Safety
General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
protection; long pants; slip-resistant, substantial
footwear; and hearing protection. Tie back long
hair and do not wear jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Never carry passengers on the machine and keep
bystanders and pets away from the machine
during operation.
•
Operate the machine only in good visibility to avoid
holes or hidden hazards.
•
Avoid mowing on wet grass. Reduced traction
could cause the machine to slide.
•
Ensure that all drives are in neutral, the parking
brake is engaged, and you are in the operating
position before you start the engine.
•
Keep your hands and feet away from the cutting
units. Keep clear of the discharge opening at all
times.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
•
Do not mow near drop-offs, ditches, or
embankments. The machine could suddenly roll
47).
17.
Installing
48).
over if a wheel goes over the edge or if the edge
gives way.
•
Stop the blades whenever you are not mowing.
•
Stop the machine and inspect the blades after
striking an object or if there is an abnormal
vibration in the machine. Make all necessary
repairs before resuming operation.
•
Slow down and use caution when making turns
and crossing roads and sidewalks with the
machine. Always yield the right-of-way.
•
Disengage the drive to the cutting unit and shut
off the engine before adjusting the height of
cut (unless you can adjust it from the operating
position).
•
Never run an engine in an area where exhaust
gases are enclosed.
•
Never leave a running machine unattended.
•
Before leaving the operating position (including
to empty the catchers or to unclog the chute), do
the following:
– Stop the machine on level ground.
– Disengage the power take-off and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all moving parts to stop.
•
Do not operate the machine when there is the risk
of lightning.
•
Do not use the machine as a towing vehicle unless
it has a hitch installed.
•
Do not change the governor speed or overspeed
the engine.
•
Use only accessories and attachments approved
by Toro.
•
This machine produces sound levels in excess
of 85 dBA at the operator's ear and can cause
hearing loss through extended periods of
exposure.
1. Wear hearing protection.
Slope Safety
•
Slopes are a major factor related to loss of control
and rollover accidents, which can result in severe
injury or death. The operator is responsible for
21
Figure 19
g229846
Advertisement
Table of Contents
