Tape dubbing
Tape dubbing (copying a pre-recorded cassette tape onto
another cassette tape) is possible with this amplifier. Both
analog and digital signal dubbing is possible.
Analog signal dubbing
Digital signal dubbing
Dubbing with 2 DAT decks connected to the DIGITAL 3, 4
IN and OUT jacks.
1 Set the REC SELECTOR switch to TAPE/DAT.
a Set the TAPE SELECTOR switch as follows:
Playback with a deck connected
Load the original cassette (master) and the cassette
being used for recording into the proper decks.
Prepare decks for recording and playback (adjust the
recording level, etc.) and then start dubbing.
Notes
@
By connecting the playback deck to the AUX jacks, and
setting the REC SELECTOR switch to AUX, dubbing is
possible on three decks by connecting them to the
TAPE 1, 2 and 3 jacks.
@
The digital signal that enters through the DIGITAL IN
terminal passes out through the DIGITAL OUT terminal
making it impossible for this amplifier to convert analog
signals to digital signals.
AKAI
36200 © ©
5060 bG626
idem Matt core anon mee 1
1 Set the REC SELECTOR switch to D/A
? Set the DIGITAL INPUT switch as follows:
Playback with a DAT deck
connected to the DIGITAL. 3
jacks
Playback with a DAT deck
connected to the DIGITAL. 4
jacks
Set to DIGITAL. 3
Set to DIGITAL. 4
Load the original DAT cassette (master) and the DAT
cassette being used for recording into the proper
decks.
Prepare the decks for recording and playback and
start digital tape dubbing.
Notes
@ By connecting the DAT deck being used for playback to
the DIGITAL. 1 (OPTICAL) terminal or the DIGITAL. 2
jack, and setting the DIGITAL INPUT switch to DIGITAL.
1 (OPTICAL) or DIGITAL. 2, dubbing is possible on 2
decks by connecting them to the DIGITAL. 3 and 4
jacks.