Analog/Digital Source Recording - Akai Reference Master AM-73 Operator's Manual

Recording
Before beginning
@ Turn on ali the components.
@ \f using a DAT deck for recording set it for analog re-
cording.
rs
Analog/Digital source recording oieitat input
Shofrarce Master vera. wreanaten aveunien AM-73
REC SELECTOR TAPE SELECTOR
OIGTAL NOISE REDUCING CONSTALCTION
- Operation
Analog recording from a digital source
1 Set the REC SELECTOR switch to D/A.
Set the DIGITAL INPUT switch according to which
jacks the playback source is connected to.
Example:
To record from a CD player
connected to the DIGITAL. 1
(OPTICAL) terminal
Set to DIGITAL. 1
Adjust the recording level of the recording deck
(cassette deck or DAT deck), and then begin record-
ing.
During recording
® Do not touch the REC SELECTOR switch or TAPE
SELECTOR switch (lower panel switch) as this will in-
terfere with recording. If you are recording from a digital
source, do not touch the DIGITAL INPUT switch.
@ If you wish to listen to another source while recording,
select that source with the INPUT SELECTOR switch.
@ If you are using a tape deck that has 3 heads, you can
monitor the sound as its being recorded by setting the
INPUT SELECTOR switch to TAPE/DAT, and then set-
ting the TAPE SELECTOR switch (upper panel switch)
according to which jacks the recording deck is con-
nected to.
Analog recording from an analog source
Set the SPEAKERS switch, DIRECT OPERATION
switch, and VOLUME control to the proper positions
for playback. Refer to page 9 for analog source play-
back details.
2 Set the REC SELECTOR switch as follows:
To record from a record Set to PHONO
To record from an FM or AM
broadcast Set to TUNER |
To record from a compact
ise Set toCD |
To record from a cassette or Set to TAPE/ DAT and
DAT cassette select with the TAPE
SELECTOR switch
To record from an auxiliary
eatikce Set to AUX
Adjust the recording level of the cassette deck or DAT
deck, and then begin recording.
@ During recording the VOLUME control and MUTING
switch can be used. If you wish to adjust the tone and
balance, set the DIRECT OPERATION switch to OFF
before recording. The signals being recorded will not
be affected by these adjustments.
When not recording
Set the REC SELECTOR switch to AUX or another position
which is not being used for playback.