Husqvarna V554X Operator's Manual page 13

4. If the engine is cold, pull up the choke control
fully.
5. Push in and turn the ignition key to the start
position.
Note:
Do not keep the ignition key in the start
position for more than 5 seconds at a time. If the
engine does not start, wait 15 seconds before
you try again.
6. When the engine starts, immediately release the
ignition key to the run position.
7. Slowly push in the choke control if the choke was
used.
8. Let the engine run at ½ throttle for 3-5 minutes
before you apply heavy load.
9. Push the throttle control to the full throttle
position.
To operate the product
1. Start the engine. Refer to
page 12 .
2375 - 003 - 13.03.2024
To start the engine on
2. Push down minimum 1 control lever to engage
the OPC.
3. Disengage the parking brake. Refer to
engage and disengage the parking brake on
page 12 .
4. Carefully push the 2 control levers forward. The
product will start to move forward. The forward
speed increases the more the 2 control levers
are pushed forward.
5. Carefully pull the 2 control levers rearward. The
product will start to move rearward. The rearward
speed increases the more the 2 control levers
are pulled rearward.
6. Put the 2 control levers in neutral position to
decrease the speed and stop the product.
7. Do the steps that follow to turn left or right when
you go in a forward direction.
a) Pull the left control lever rearward in the
direction of the neutral position to make the
product turn left. The more you pull the left
control lever rearward, the more the product
will turn left.
To
13