Table of Contents
Advertisement
3
2
1
1. Junction box louvered panel
2. SCR module
3. Relay board
4. Engine harness-to-controller connection
5. Generator set master switch
6. ADC 2100
7. Line circuit breaker plate
8. Junction box
Figure 9-3 Advanced Digital Control (ADC 2100)
8. Disconnect the LO and GRD lead connections.
9. Remove the junction box, SCR module, and relay
board as necessary. See Figure 9-3.
10. Disconnect the FP and FN leads.
68
Section 9 Generator Disassembly/Reassembly
11. Remove the four bolts to remove the exciter field, if
4
5
6
7
1. Bolts (4)
8
2. Exciter field
Figure 9-4 Exciter Field Removal
12. Remove the three bolts and spacers from the
13. Disconnect the main field rotor leads from the
14. Remove the armature from the shaft, guiding the
1. Armature
2. Armature retaining bolt
3. Rotor leads
4. Rectifier board
Figure 9-5 Armature Removal
equipped. See Figure 9-4.
1
2
rectifier board.
rectifier
board
positive/negative
Remove the armature retaining bolt and washer.
See Figure 9-5.
rotor leads through the armature bores.
Figure 9-5.
1
558864
terminals.
See
2
3
4
558865
TP-6359 7/08
Advertisement
Table of Contents
