Operation Instructions; Lowering And Raising The Blade; Adjusting The Blade Angle - Exmark LAZER Z CT Operator And Parts Manual

4. OPERATION INSTRUCTIONS

IMPORTANT: This snow blade should be used for plowing snow only.

4.1 LOWERING AND RAISING THE BLADE

Lowering the Blade
1. Move the hairpin cotter and clevis pin to the lowest position in the height-of-cut bracket (Fig
11.)
2. Slowly lower the height-of-cut lever.
Raising the Blade
1. Raise the height-of-cut lever to the transport position (highest height of cut).

4.2 ADJUSTING THE BLADE ANGLE

There are five positions for the side to side angle of the blade. To change the blade angle,
perform the following procedure.
1. Raise the blade.
2. Push the index lever forward with one hand (Fig. 12) while positioning the blade with the
other hand until you have reached the desired blade angle.
3. Release the index lever.
NOTE: The angle pin must snap into a hole in the channel to retain the blade position.
Figure 11
Figure 12
- 9 -