Rear Panel - Panasonic RAMSA WZ-AD96 Operating Instructions Manual

Getting Started
Notes:
• Out channel selection is not available if 44.1 kHz or 48
kHz is selected for the reference source.
• When the DUAL AES/EBU card is installed in the unit, Out
channel selection is also available. Selecting 5-8 will result
in that contents of the channel 5-8 are supplied to both the
output channel 1-4 and 5-8 of the card.
© < OUT Channel Selection> Indicator [44.1k 88.2k 48k
96k]
FREQ
44,1k [ZD I 88.2k 1
48k CPI 96k |
□
I CH-SEL I
The upper LED (44.1 kHz, 88.2 kHz) lights in green when a .set of
4 is selected, or the lower LED (48 kHz, 96 kHz) lights when a set
of channel 5-8 is selected.
© < Calibration> Button [CAL]
Calibration to the clock synchronization is carried out manually by
pressing this button. Digital outputs are mute during calibration.
channel 1*
CLOCK
CP CRYSTAI
CP EXT
I—I ERROR
□
Q) <Calibration> Indicator [CRYSTAL EXT ERROR] S3
Error indicator lights in red during calibration for about 1 second.
® <Shift Mode> Button [SHIFT]
Press this button to enter or to quit the shift mode.
® <Shift Mode> Indicator [24bit 20bit l6bit]
All three indicators light during the shift mode.
LENGTH
1 1 24tat
CP 2CM
CP 16W
□
fSHiFT]
REAR PANEL
For AJD96
® Analog Input connector [1-8 ANALOG INPUT +4 dB lOkH (BAL)]
These XLR connectors accept analog signals supplied by external devices.
Input level is +4 dB for each channel. See the next page.
For AD96M
<5j)
^ Analog Input connector [1-8 ANALOG INPUT -60 dB to +4 dB lOkH
(BAL)]
These XLR connectors accept analog signals supplied by external devices.
Input level is adjustable with a trimmer from -60 dB to +4 dB for each
channel. See the next page.
16