Table of Contents
Advertisement
Parameter
Restore NVDIMMs
Interleave NVDIMMs
Assert ADR on Reset
Assert ADR on S5
Get Memory Timing
Memory Topology
Memory Map
(Note)
Memory RAS Configuration
(Note)
Advanced items prompt when HBM CPU is installed.
Description
Enable/Disable Automatic restoring of NVDIMMs.
Options available: Enable, Disable. Default setting is Enable.
Controls if NVDIMMs are interleaved together or not.
Options available: Enable, Disable. Default setting is Enable.
Enable/Disable Assert ADR on Reset.
Options available: Enabled, Disabled. Default setting is Disabled.
Enable/Disable Assert ADR on S5.
Options available: Enabled, Disabled. Default setting is Disabled.
Auto is the detected SPD value and use it, otherwise use BIOS Build-in.
Options available: Auto, BIOS Build-in. Default setting is BIOS Build-in.
Press [Enter] to view memory topology with DIMM population
information.
Press [Enter] to configure advanced items.
Volatile Memory Mode
Š
– Selects 1LM or 2LM mode for volatile memory.
– Options available: 1LM, 2LM. Default setting is 2LM
Press [Enter] to configure advanced items.
RAS Type
Š
– Displays the RAS type.
New SDDC Mode
Š
– Enable/Disable 48B SDDC ECC from ICX C0 Onwards.
– Options available: Disabled, Enabled. Default setting is
Enabled.
Mirror Mode
Š
– Mirror Mode will set entire 1LM memory in system to be
mirrored, consequently reducing the memory capacity by half.
Enables the Mirror Mode will disable the XPT Prefetch.
– Options available: Disabled, Full Mirror Mode, Partial Mirror
Mode. Default setting is Disabled.
Correctable Error Threshold
Š
– Correctable Error Threshold (0x01-0x7fff) used for sparing, and
leaky bucket.
– Press the <+> / <-> keys to increase or decrease the desired
values.
Trigger SW Error Threshold
Š
– Enable/Disable Sparing trigger SW Error Match Threshold.
– Options available: Disabled, Enabled. Default setting is
Disabled.
BIOS Setup
- 79 -
Advertisement
Table of Contents
