Tuning Operations - Yamaha TX-590RDS Owner's Manual

Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING).
1
AUTOMATIC TUNING
1
Turn the power on.
2
Select the reception band (FM or AM) confirming it on
the display.
FM/AM
3
TUNING MODE
AUTO/MAN'L MONO
4
Tune to a desired station.
PTY SELECTOR
To tune to a higher frequency, slightly turn the control to
the right. To tune to a lower frequency, slightly turn the
control to the left.
5
If the station where tuning search stopped is not the
desired one, turn again.
PTY SELECTOR
* If the tuning search does not stop at the desired station
(because the signals of the station are weak), change
to the MANUAL TUNING method.

TUNING OPERATIONS

POWER
RDS MODE/FREQ PTY SEEK
MODE START
POWER
or
AUTO
MHz
0 20 l00
TUNING
TUNING
PRESET STATIONS
A/B/C/D/E 1 2 3 4
MEMORY
MAN'L/AUTO FM
5 6 7 8
EON FM/AM TUNING MODE EDIT
AUTO/MAN'L MONO
2 3
MANUAL TUNING
1
Turn the power on.
2
Select the reception band (FM or AM) confirming it on
the display.
FM/AM
3
TUNING MODE
AUTO/MAN'L MONO
4
Tune to a desired station manually.
Notes
When tuned in to a station, the frequency of the received
station is shown on the display. If an RDS station that
employs PS data service is received, the frequency is then
replaced by the station name. Refer to page 15 for details.
If you tune to an FM station manually, it is received in
monaural mode automatically to increase the signal quality.
To turn off the power
Press the POWER switch again.
TUNING
4, 5
PTY SELECTOR
POWER
or
MHz
0 20
Turn "AUTO" off.
TUNING
PTY SELECTOR
l00
9