Motorola V200 Service Manual page 72

Dual band personal communicator, cdma 800/1900 mhz technology
Hide thumbs Also See for V200:
Table of Contents

Advertisement

Troubleshooting
68
30000009000000360001000000
3000000A00000006000200003400
30000009000000050001000003
3000000B000000000003000000002A
• Send the above test commands to generate a tone to CE bus connector
AUDIO_OUT J1000 pin 15. If the signal is present on J1000 pin 15 but no audio,
J1000 may be defective.
• No signal at the J1000 pin 15, check signal at C1221 and C1212.
If the signal is coming out of AUDIOOUTP and AUDIOOUTM, check
U1200 and the parts associated with A0A, A1 and A4 U1200 amplifiers.
If no signal is present at C1221 and C1212, either defective U1100 or
cold solder / missing power supply to U1100.
Tones Present but No Voice
• Send the following test commands. 13K Loop back with internal speaker and
internal Mic (suspend, CP mode CDMA, AUD_LPB, Headset path UN-muted,
Aud_Lvl 3).
30000009000000360001000000
300000090000000A0001000001
30000009000000040001000003
3000000A00000006000200003400
30000009000000050001000003
• Inject 43.5 mVrms, 1kHz signal to the CE bus connector analog audio input
J1000 pin 16. Check U1100 pins P14 and N15 AUDIOOUTP and
AUDIOOUTM.
• If no signal, check U1100 (ensure U1100 pin P15 MIC1 has the same signal as
the CE bus AUDIO_IN).
• If there is signal (+/-17 mVrms) and the tone is present on the CE bus
AUDIO_OUT, place the UUT into call with test set (HP8924) with service
option 1 with 1kHz tone enabled. If there is no tone, it could be defective
U1100 CSP.
Troubleshooting the Speakerphone
No or Low Speakerphone Tones
• Test commands: Suspend, Headset speaker, Volume level, Speakerphone tone.
30000009000000360001000000
3000000A00000006000200002300
30000009000000050001000007
3000000B000000000003000000002A
• Send the above test commands to generate a speakerphone tone to the speak-
erphone.
If the signal is on the U9925 pin 1, but no audible speakerphone or low
speakerphone, inspect the speakerphone connections and check U9925
pin 6 for DC voltage.
Otherwise, replace U9925.
• No signal at U9925 pin 1, check signal at C1221 and C1212.
October 04, 2001
CDMA V200
6881039B10

Advertisement

Table of Contents
loading

Table of Contents