Table of Contents
Advertisement
<.) Playing a Digital Program
Source
1. Set the DIGITAL
DIRECT
switch @ to the "ON"
position. Indicator @ will light.
2. Select the desired
program
source
with the INPUT
SELECTOR
(digital input switching)
and the DAT
MONITOR.
)
|
PROGRAM
SOURCE
INPUT SELECTOR
DAT MONITOR
|
Digital source with optical output
DIGITAL-1
OFF
Digital source
with
a coaxial
type digital output
DIGITAL-2,
3
OFF
Coaxial
type digital source
from
DAT
-
ON
The sampling frequency indicator will light up in correspondence with the sampling frequency of the digital signal that has
For information on the operating
method,
refer to the operating
instructions for the various components.
4. Adjust the volume.
:
(© Analog Recording to the Tape Deck and Tape Copying.
1. Select the program
source that you wish to record with the MONITOR/COPY
(recording output switching).
PROGRAM
SOURCE
MONITOR/COPY
When
recording program
sources connected to PHONO
~ AUX/VIDEO-2
P
SOURCE
;
When
recording
from
the component
connected
to the TAPE-1
terminals
to TAPE-2
|
TAPE-1
/ 1>2
.
1
When
recording from the component connected to the TAPE-2 terminals to TAPE-1
TAPE-2 / 21
ia
When
recording
a program
source
connected to DIGITAL-1, 2, 3 DAT
MONITOR
DAC
OUT
(Set the DIGITAL
DIRECT
switch to
"ON"
at this time)
|
Don't change the MONITOR/COPY
switch while recording, or you will get intermittent sounds.
2. Begin playing the program
source.
3. Begin recording with the tape deck.
For information on the operating
method,
refer to the operating
instructions for the various components.
') Digital Copying to the Digital Tape Deck
NOTE:
In some
cases digital copying
is not possible due to differences
in sampling
frequency, etc.
For digital tape decks equipped with digital recording input terminals, copying of the unchanged digital signal from the DAT
OUT
terminals is possible.
j
1. Set the DIGITAL DIRECT switch @ to "ON".
2. Select the program
source that you wish to record with the DIGITAL
INPUT SELECTOR
(DIGITAL-1,
2, 3).
3. Begin playing the digital program
source.
)
4. Begin recording with the digital tape deck.
For information
on the operating
method,
refer to the operating instructions for the various components.
© Monitoring the Recording
A recording in progress can be monitored if a tape deck with three individual heads for recording and playback is used. A tape
deck
in which a common
head
is used for both recording and playback cannot
be used to monitor recording.
Set the MONITOR/COPY knob of TAPE-1 or TAPE-2 to corresponding to the tape deck that is being used for the recordin g. Use
the MONITOR/COPY
switch to switch between
the recording monitor and the program
source.
NOTE:
When digital signals are being input from a CD player, DAT, etc., noise may be produced from the DAP-2500A if the
power of the component sending digital signals is turned off before the power of the DAP-2500A. We recommend
either turning off the power of the DAP-2500A first, or turning down the DAP-2500A's main volume control before
turning off the power
of the CD player, DAT, etc.
13
Advertisement
Table of Contents
