Antenna Connections - Yamaha HTR-5150 Owner's Manual

Natural sound av receiver
Hide thumbs Also See for HTR-5150:
Table of Contents

Advertisement

ANTENNA CONNECTIONS

Each antenna should be correctly connected to the designated terminals, referring to the following diagram.
Both AM and FM indoor antennas are included with this unit. In general, these antennas will probably provide sufficient signal
strength. Nevertheless, a properly installed outdoor antenna will give clearer reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may result in improvement.
Outdoor
* You may be unable to obtain good FM radio
FM antenna
reception depending on your local
conditions (distance from the broadcast
station, interposing buildings and
mountains, etc.). Consult your dealer or
authorized service center and be sure to
install an antenna that suits your local
conditions.
Install the special FM outdoor antenna in a
high place as far away from any roads as
possible to avoid being affected by
automobile ignition noise.
75-ohm/300-ohm
antenna adapter
75-ohm coaxial cable
75-ohm/300-ohm
antenna adapter
300-ohm feeder
Connecting the AM loop antenna
1
1 Press the tab and unlock the terminal hole.
2 Connect the AM loop antenna lead wires to the
AM ANT and GND terminals.
3 Return the tab to its original position to lock the
lead wires. Lightly pull the lead wires to confirm
a good connection.
1
3
2
• The AM loop antenna should be placed away from this unit. The antenna may be hung on a wall.
• The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.
20
Indoor FM antenna
(included)
* Firmly insert the
connector into the FM
ANT terminal.
(U.S.A. model)
GND terminal
Ground
For maximum safety and minimum interference, connect the
GND terminal to a good earth ground. A good earth ground
is a metal stake driven into moist earth.
2
Attach the loop antenna to the
antenna stand.
Loop antenna
Antenna stand
Outdoor AM antenna
* If you cannot obtain good
reception with the AM loop
antenna, connect 5 m to
10 m of vinyl covered wire
to the AM ANT terminal
and extend it outdoors
from a window. (Be sure
to also connect the AM
loop antenna at this time.)
AM loop
antenna
(included)
3
Orient the AM loop
antenna so that the best
reception is obtained.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents