Tuning - Yamaha HTR-5150 Owner's Manual

Quick automatic-search tuning (AUTOMATIC TUNING) is effective when station signals are strong and there is no interference.
However, if the signal from the station you want to select is weak, you must tune in to it manually (MANUAL TUNING).
AUTOMATIC TUNING
Set the SELECTOR DIAL to the AMP/TUN position on the remote control and select TUNER as the input source.
1
Select the reception band (FM or AM) and confirm it on
the display.
Front panel
2
Press TUNING MODE so that the "AUTO TUNING"
indicator lights up on the display.
Front panel
3
To tune in to a higher frequency, press the UP side of
TUNING once.
To tune in to a lower frequency, press the DOWN side
of TUNING once.
Front panel
* If the station where the tuning search stops is not the
desired one, press once more.
* If the tuning search does not stop at the desired station
(because the signal from the station is weak), take the
manual tuning procedure.
30

TUNING

2
1
MANUAL TUNING
1
or
2
3
Lights up
* To continue the tuning search, press and hold the button.
Notes
• If you tune in manually to an FM station, it will be automati-
cally received in monaural mode to increase the signal
quality.
• When tuned in to a station, the frequency of the received
station is shown on the display.
3
Select the reception band (FM or AM) and confirm it on
the display.
Front panel
Press TUNING MODE.
Front panel
Tune in manually to the desired station.
Front panel
or
Check that the "AUTO
TUNING" indicator goes off.