Table of Contents
Advertisement
2. Scroll through the pages until the item "Coffee mill settings" is
displayed.
3. Press "Read more"; to watch tutorial on how to adjust the level of
grinding. Press "Next" or "Back" to read the advice.
4. When at the final page, press "Ok" to go back to the settings menu.
5. Press "X" to go back to the homepage.
Please note:
•
After completing the above procedure, at least 3 coffees should
be prepared and delivered before making any further adjustment
to the coffee mill. If coffee delivery is still not correct, repeat the
procedure.
•
The adjuster ring must be turned only when the coffee mill is in
operation during the initial step of coffee preparation.
Bean Adapt Technology
We suggest accessing Bean Adapt Technology from the homepage, so
that this parameter can be set as appropriate for the particular coffee
bean used.
Water hardness
To enter a new water hardness setting, proceed as follows:
1. Measure the water hardness as described above, see
hardness of the
water".
2. Press
to access the settings menu (fig. 11).
3. Scroll through the pages until the item "Water hardness" is dis-
played. Press "Set".
4. Select the level corresponding to the result give by the test strip.
5. Press "<" to go back to the settings menu;
6. Press "X" to go back to the homepage.
Empty circuit
To avoid the water in the circuit freezing if the machine is to be left idle for
an extended period, or before taking it to a service centre, it is advisable
to drain the water circuit.
Proceed as follows:
1. Press
to access the settings menu (fig. 11).
2. Scroll through the pages until the item "Empty circuit" is displayed.
3. Press "Ok" to start the guided procedure;
4. Remove, empty and reposition the grounds container and the drip
tray (fig. 14), then press "Next";
5. Position a container of 0.2l capacity under the spouts (fig. 9). Press
"Next".
6.
The machine runs a rinse cycle, delivering hot water from the spouts;
17
:
"Check the
Advertisement
Table of Contents
