Table of Contents
Advertisement
404 Breakdown assistance
Do not tow the vehicle in these situa-
#
tions.
* NOTE Damage due to excessive tractive
power
If you pull away sharply, the tractive power
may be too high and the vehicles could be
damaged.
Pull away slowly and smoothly.
#
Loading the vehicle for transport
Requirements
The vehicle is stationary.
R
The vehicle is switched off.
R
The driver's display is in the initial state with
R
no menus open (
page 304). Transportation
/
is possible even if a warning message is visi-
ble.
The 12 V battery is charged.
R
If necessary, set the system language
#
(
page 338).
/
Observe the notes on towing away
#
(
page 402).
/
Connect the towing fixture to the towing eye in
#
order to load the vehicle.
Switch on the power supply (
/
#
Put the selector lever into position i.
#
%
The selector lever may be locked in position
j in the event of electrical malfunctions. To
shift to i, supply the on-board electrical sys-
tem with power (
page 401).
/
* NOTE Possible damage to the vehicle
when loading or unloading
When loading or unloading, the vehicle must
be raised to transport level.
If the transport settings are not shown or the
Vehicle Not Ready for Loading
message is
displayed, the vehicle may not be loaded or
unloaded.
If required, raise the vehicle to transport
#
level again.
A vehicle that cannot be raised to trans-
#
port level may not be loaded or unloaded
using a ramp. Consult a qualified special-
ist workshop.
page 192).
& WARNING Risk of accident due to activa-
ted transport level
If the vehicle is raised to transport level, driv-
ing and driving safety systems have only limi-
ted availability and the view from the vehicle is
restricted.
Driving safety is severely restricted and there
is a risk of an accident!
Do not use transport level in normal road
#
operation.
Advertisement
Table of Contents
