Adjusting The Volume - Yamaha Mark III User Manual

Adjusting the Volume

You can adjust volume with the Control Unit or
with the remote control as described below. Since
all piano songs are recorded at the maximum
volume level of 0, volume can be decreased down
to –10, the softest volume at which the piano can
play.
For Ensemble songs, the volume of the piano and
internal XG tone generator are adjusted
simultaneously, so it is a good idea to first balance
the volume of the piano and XG tone generator.
See "Balancing the Ensemble Volume (TG Master
Balance)" on page 26.
For songs on PianoSoft . PlusAudio, you should
first balance the volume of the MIDI piano and
Audio parts.
See "Balancing the CD Volume (CD Master
Balance)" on page 27.
The LED volume level indicators show volume
levels in the manner shown below. For example,
when two consecutive indicators are lit, the
volume level is between these two levels.
LED
Volume
-10 -8 -6 -4 -2 0
0
-1
-2
-3
-4
-5
Note: Make sure the VOLUME knob on the
Amplifier is set to an appropriately audible
level. If the volume knob on the Amplifier is
turned fully counterclockwise, no sound may
be produced even when you adjust the volume
on the Control Unit.
Once you set the volume of the Amplifier, you
do not need to adjust it frequently.
The volume level setting is saved when another
song is selected, another disk inserted or selected,
or when the Disklavier is turned off.
Note: This setting does not affect manual playing.
LED
Volume
-10 -8 -6 -4 -2 0
-6
-7
-8
-9
-10
a
On the Control Unit, press the
Selector until the VOLUME
indicator lights. Then press [–/NO]
to decrease or [+/YES] to increase
the volume.
VOLUME
TEMPO
TRANSPOSE
BALANCE
b
On the remote control, use the
[VOLUME] buttons to adjust the
volume.
VOLUME
–
Remote Control
[–] decreases the volume, and [+] increases
the volume.
–/NO +/YES
+
25