Yamaha Mark IV Connection Manual

6/4/2011
Online Services
MARK IV INTERNET CONNECTION GUIDE
Connection Example
Wireless connection
*He re , "m ode m " re fe rs to an ADSL m o de m , optica l ne twork unit (O NU),
or cable m ode m .
Instructions
PURCHASE A
COMPATIBLE LAN
BRIDGE DEVICE
CONFIGURE THE
BRIDGE ADAPTER
ATTACH
ETHERNET CABLE
To your Disklavier
PRESS
Still can't connect? Follow these instructions...
SS
...yamaha.com/connect/wirelessType?t...
Yamaha: Connect to Radio Service For ...
*Modem
Access point
Wireless bridge device
Ethernet cable
Any LAN bridge compatible with your network should allow you to
connect your instrument wirelessly. However, the following devices
have been fully tested and are recommended for use with Yamaha
instruments:
LINKSYS WET610N
BUFFALO WLI-TX4-AG300N
You may need to refer to the manufacturer's instructions to
configure your adapter. A full list of compatible adapters is available
at the Yamaha Download
Set up your adapter to connect to your wireless network, following
the directions provided for your adapter. If you have any problems
connecting the bridge device to your network, please contact the
device manufacturer for further support.
Attach one end of an Ethernet cable to the rear port of the bridge
adapter and the other end to the Ethernet port on your Disklavier.
Press the [Internet] button. Congratulations, you are now
connnected. You should see the Internet Direct Connection home
page.
If you see a screen saying that you are not successfully connected,
Site.
1/2