How To Operate; Power Button - HoMedics CMTF45 Instruction Manual And Warranty Information

ABOUT WHITE DUST
Use of high mineral content hard water may cause a white mineral residue to accumulate
on surfaces in the room near the humidifier. The mineral residue is commonly called "white
dust." The higher the mineral content (or, the harder your water is), the greater the potential
for white dust. The white dust is not caused by a defect in the humidifier. It is caused only by
minerals suspended in the water.

HOW TO OPERATE

Insert single pin plug into the top of the humidifier, then plug the
adapter into a 120-volt AC electrical outlet.

POWER BUTTON

Turns humidifier on/off.
MIST OUTPUT
Mist adjusts from the lowest output (1) to the highest output (3). To increase the mist
output, press the mist output
display. Do not point the mist nozzle toward walls or furniture.
TIMER
Press the timer button until the desired auto-shutoff timer setting is displayed. The
timer button will cycle through the following settings: 4, 8, 12 hours and off. To cancel
the timer at any time, press the timer button until all LEDs are off.
NOTE: Always be sure the humidifier has a full tank of water prior to using the timer setting.
NIGHT-LIGHT/DISPLAY LIGHTS
Press the night-light
CLEAN REMINDER
The LED above the clean icon will illuminate red indicating it is time to clean the
transducer/ultrasonic membrane. See cleaning instructions in the How to clean and
care section. Press and hold the timer
turns off.
button. The corresponding mist level will be lit on the
button to turn the night-light on/off.
and night-light
7
buttons until the red light