Safety Precautions - Kenwood 1050MD Instruction Manual

Introduction
Before applying power
Units are designed for operation as follows.
U.S.A. and Canada
.
*050MD 'E-;
L
Caution: Read this section carefully to ensure safe operation.
AC 120 V only
Safety precautions
/i\
Caution: Read this section carefully to ensure safe operation.
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.
A
CAUTION
A
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
A
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO ALERT
THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE
that MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
A
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE
OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING
THE APPLIANCE.
The marking of products using lasers
REQUIREMENT BY NEDERLAND GAZETTE
(Except for some areas)
1 CLASS 1 1
they empty, you Should not throw away. Instead,
1 LASER PRODUCT |
nand tnem in as small chemical waste. 1
T-^e mark.ng is located on the rear panel and says that the comoonent
uses laser beams that have been classified as Class 1 It means that
the unit is utilizing laser beams that are of a weaker class. There is no
danger o^ hazardous radiation outside the unit.