Erasing The Track Being Played (Track Erase) - Kenwood 1050MD Instruction Manual

'050MD IE-:
Use the following procedure to erase a single track being
played.
Be careful in using this operation because a track cannot be
recovered once it has been erased.
-----
\
Preparation
O Play a MD.
© Press the EDIT/SPACE key to switch the
editing mode on.
Erasing the track being played (TRACK ERASE)
Select "ERASE".
The modes are switched by rotating the JOG DIAL.
1
DIVIDE?
; Dividing a track
2
COMBINE?
. Combining tracks
i
ERASE?
: Erasing trackisi
— 4 MOVE?
: Moving (reordering) tracKS
• Editing is aborted if no operation has been performed fo' 8 seconds.
Confirm that the track has been erased.
Execute the track erasure operation.
-
—
Confirm that the track has been erased.
Display after execution
"EDIT NOW!"
: When editing is in progress
"COMPLETE!"
: When editing is completed successfully
"CAN'T EDIT"
■ When editing is incomplete
• It takes a while until the execution completes.
• The track being played is erased (together with its track title).
• If you execute an editing operation by mistake, the condition before
editing can be recovered by performing the
"EDIT CANCEL"
op^-